BMYLK - A869, KITTY HAIR

Product Identification

Product ID:A869, KITTY HAIR
MSDS Date:10/09/1990
FSC:8040
NIIN:00N028869
MSDS Number: BMYLK

Responsible Party
FIBRE GLASS-EVERCOAT CO INC
6600 CORNELL ROAD
CINCINNATI, OH 45242
US

Emergency Phone: 800-424-9300 (CHEMTREC)

Info Phone: 800-729-7600

Preparer: JEFF ZYCH

Cage: 18731

Contractor
FIBRE GLASS-EVERCOAT CO INC
CINCINNATI, OH 45242 US

Telephone: 513-489-7600

Cage: 18731

Ingredients

295 F.

CAS: 100-42-5

RTECS: WL3675000

Fraction By Weight: 22.40%

OSHA PEL 100 PPM

ACGIH TLV: S,50PPM/100STEL;9293

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS


POLYESTER RESIN

Fraction By Weight: 30%


TALC (POWDER), CONTAINING NO ASBESTOS FIBERS

CAS: 14807-96-6

RTECS: WW2710000

Fraction By Weight: 40%

OSHA PEL 2 MG/M3, RDUST

ACGIH TLV: 2 MG/M3, RDUST


FIBROUS GLASS

CAS: 65997-17-3

Fraction By Weight: <5.0%

OSHA PEL 5 MG/M3 RDUST

ACGIH TLV: 10 MG/M3 DUST

Hazards

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:YES OSHA:NO
Health Hazards Acute and Chronic:INHAL:VAPORS MAY CAUSE NOSE, THROAT &
RESPIRATORY TRACT IRRITATION. HIGH CONCENTRATIONS MAY CAUSE
HEADACHE & NAUSEA. REPEATED HIGH CONCENTRATION EXPOSURE MAY CAUSE
LIVER & KIDNEY DAMAGE. SKIN:PROLONGE D/FREQUENT CONTACT MAY CAUSE
DEFATTING,DRYNESS W/ IRRITATION & POSSIBLE DERMATITIS. EYE CONTACT
MAY (EFTS OF OVEREXP)
Explanation of Carcinogenicity:STYRENE:GROUP 2B (IARC).
Effects of Overexposure:HLTH HAZ:CAUSE TEARING & IRRITATION. SKIN
ABSORP:DERMATITIS & IRRITATION. INGEST:MAY CAUSE GI DISTURBANCES,
PAIN & DISCOMFORT. INHALATION OF REPEATED HIGH CONCENTRATIONS MAY
CAUSE LIVER AND KIDNEY DAM AGE.
Medical Cond Aggravated by Exposure:LIVER & KIDNEY DISORDERS.

First Aid

First Aid:SKIN:WASH WITH SOAP & WATER. EYE:FLUSH WITH WATER FOR AT
LEAST 15 MINUTES AND GET MD. INHAL:MOVE FROM EXPOSURE. IF CONSCIOUS
GIVE ARTF RESP OR O2 AS NEEDED. GET MD. INGEST:DO NOT INDUCE
VOMITING (ASPI RATION HAZARD). GET MD.

Fire Fighting

Flash Point Method:CC
Flash Point:98.0F,36.7C
Lower Limits:1.1%
Upper Limits:6.1%
Extinguishing Media:FOAM, ALCOHOL FOAM, CO2, DRY CHEMICAL, WATER FOG.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:POLYMERIZATION MAY TAKE PLACE AT ELEVATED
TEMPERATURE SUCH AS IN A FIRE. IF CONTAINED, VIOLENT RUPTURE MAY
RESULT.

Accidental Release

Spill Release Procedures:REMOVE SOURCES OF IGNITION. ABSORB SPILL WITH
ABSORBENT MATERIAL SUCH AS VERMICULITE OR SAND.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:AVOID STORAGE ABOVE 100F. STORE ONLY
IN ORIGINAL CONTAINERS.
Other Precautions:NONE SPECIFIED BY MANUFACTURER.

Exposure Controls

Respiratory Protection:A NIOSH/MSHA APPROVED CANISTER TYPE RESPIRATOR
MUST BE WORN TO PREVENT THE INHALATION OF VAPORS OR SPRAY MISTS
WHEN THE TLV OR PEL IS EXCEEDED. WEAR A NIOSH/MSHA APPROVED DUST
MASK WHEN SANDING THE CU RED PRODUCT.
Ventilation:PROVIDE SUFFICIENT MECHANICAL (GENERAL AND/OR LOCAL
EXHAUST) VENTILATION TO MAINTAIN EXPOSURE BELOW TLV.
Protective Gloves:PLASTIC OR CHEMICAL RESISTANT GLOVES.
Eye Protection:CHEM WORK GOGG/FULL LENGTH FSHLD .
Other Protective Equipment:USE A BARRIER CREAM SUCH AS GLOVE COAT WHEN
USING THIS PRODUCT.
Work Hygienic Practices:REMOVE AND WASH CONTAMINATED CLOTHING. WASH
HANDS BEFORE EATING AND DO NOT SMOKE WHILE USING.
Supplemental Safety and Health
SPEC GRAV:1.56 (H2O=1).

Chemical Properties

HCC:F4
Boiling Pt:B.P. Text:SEE ING 1
Vapor Pres:SEE ING
Vapor Density:HVR/AIR
Spec Gravity:SUPP DATA
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:NIL
Appearance and Odor:PASTE, SHARP AROMATIC ODOR

Stability

Stability Indicator/Materials to Avoid:YES
STRONG ACIDS AND OXIDIZING AGENTS.
Stability Condition to Avoid:HEAT AND DIRECT SUNLIGHT.
Hazardous Decomposition Products:HEATING TO DECOMPOSITION MAY CAUSE
IRRITATING AND ACRID FUMES.
Conditions to Avoid Polymerization:IF HAZARDOUS POLYMERIZATION OCCURS
WHILE CONTAINED IN A CLOSED CONTAINER, VIOLENT RUPTURE MAY RESULT.

Disposal

Waste Disposal Methods:SMALL QUANTITIES CAN BE REACTED WITH THE
APPROPRIATE HARDNER TO SOLIDIFY. DISPOSE OF IN ACCORDANCE WITH ALL
FEDERAL, STATE, AND LOCAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.